Cold Dead Hands Gunsmith

Installed a pistol optics green dot for a customer and sighted it in at 25 yards. Test fired at 7 yards, shots were about where expected at that range.

Happy July 4th and 250 years of America!

Finished build of previous post.

Built a lower receiver today. Palmetto State Armory has affordable products and I have never had an issue with them. Followed AR specs and torqued the castle nut to 40 ft lbs. I'll throw on an upper and take it to the range for testing.

Took this old Wi******er in from a customer. It is missing the fire control system and I am looking to get parts to rebuild it.

The Banish 9 on the G***k 19 gen 5 looks great. But while testing function I found an issue. The recoil spring assembly hits the bottom of the suppressor attachment and will not cycle leaving the spent round in the chamber. Looking in to solutions to this issue.

Shooting with a suppressor is different. The suppressor is slightly taller than standard sights. Will probably add suppressor height sights.

My official endorsement as an American Gunsmith Institute approved service center.

This weekends project was installing this suppressor on the G***k